5/17/2023 Wednesday
Hi Guys! I’m back with number 3… It’s actually an additional something from last weeks design on the base card. You will see when you see photos and understand what I’m saying..
Just a few quick notes on a couple of things, you will attach the flap to the base before you add DSP or inside stuff and it’s important to do that so it’s covered and looks good.
I didn’t give you any photos showing this step but you can tell from the inside photos I’m going to share with you with all the photos i upload, and boy do I hope this goes a lot smoother than it has the last few times. There is going to be a large number of photos following this so please enjoy. Unlike most times I’m going to give you the size of made now.
Base card is 5 1/2” x 8 1/2” score at 4 1/4” and cut 1” off front of card (see photos)
Same color as base or you change it up that might be cool too.
Flap piece is 3 1/2”x 7” score at 3 1/2” you will glue or use tear tape to adhere this piece the the base of card inside, line up the edges making sure they are even.
Layers are pretty simple if it’s a single one we will have here I adjust on some to make a little different but I’m only listing the base stuff. You can change however you want on your designs.
Front DSP or White in some cases is ALWAYS 3” x 5 1/4” work from there to make layers. This is also the same size as inside white.
the strip on the inside but shows on the from you will make this piece 1” x 5 1/4” , if you use a base under it you need to make base this use and the dsp will change. But again I’m only giving you base sizes. Remember this and have fun,
3 current sets
3 current 1 retired
Please note here, colors in c/s are Berry Burst, and Bubble Bath, but on the center of flower that is base bubble bath c/s, I used sponge dauber to go around edges first in Moody Mauve then in Berry Burst… just FYI! The is also up on a dimensional.
Okay I give, UNCLE<UNCLE< UNCLE!!!!!
I can’t get the photos to load and this little bit has taken forever… I will try again later.
Comments